Return to site

When using photographing measurement, why the measurement error exceeds 5%?

· FAQ - Ruler Pro

When using photographing measurement, why the measurement error exceeds 5%?

Please confirm the following matters :

> Is the photography technique correct?

A: Do not hit the laser spot on the glass or the surface that cannot reflect the laser signal.

> Is the measurement technique correct?

When measuring three axes...

Q: Is the three-axis center point (green dot) on the same horizontal plane as the laser point?

A: If the green dot and the laser spot are not on the same plane, it will cause the measurement error.

Q: Is the blue dot correctly set to high?

A: If the blue dot is set to the horizontal length or width, the measurement value will be incorrect.

When measuring area

Q: Is the laser point on the same level as the area to be measured?

A: If the area to be measured and the laser spot are not set on the same horizontal plane, the measured value will be incorrect.

> Is the hardware installed correctly?

A: For details, please refer to here.

> Has any calibration been performed?

A: For details, please refer to here.

If none of the above can improve the situation where your measurement error is still too large, Please send "Report Error" to us for root analysis.